In this episode we show you how we built new bulkheads using 18mm marine plywood, which we then sealed with epoxy, and are going to glass completely … This article was gathered automatically by our news bot. We help YouTubers by driving traffic to them for free. The featured image in this article is the […]
Continue Reading
In this episode we get almost all of the tabbing done inside the boat, which connects the bulkheads to the hull. It is a huge accomplishment, and we have so … This article was gathered automatically by our news bot. We help YouTubers by driving traffic to them for free. The featured image in this […]
Continue Reading
As if things couldn’t get any worse, we pull off the plywood trim to discovery that the bulkheads were actually completely rotten from being wet, on both sides. This article was gathered automatically by our news bot. We help YouTubers by driving traffic to them for free. The featured image in this article is the […]
Continue Reading
In this episode we finish the last little bit of fiberglass work to be done on our Lagoon 450 catamaran. We use epoxy to reinforce every single bulkhead in the boat, and end up with the strongest Lagoon 450 in the world! But, rebuilding the cabins may not be such an easy task! This series […]
Continue Reading
Grinding fiberglass inside the boat is the hardest work we have ever done. Hands down. The Panamanian heat making it all that much more difficult as well. This article was gathered automatically by our news bot. We help YouTubers by driving traffic to them for free. The featured image in this article is the thumbnail […]
Continue Reading
In this episode we make a discovery which shows the real extent of the damage to our bulkheads. We receive some extremely helpful assistance from the manufacturer, on how to repair our Lagoon 450 catamaran. She has had catastrophic failures to both sides of her primary bulkhead, leading to the fracture of subsequent bulkheads, and […]
Continue Reading
Colin finally gives his opinion on the Lagoon 450 design flaw involving the weak bulkhead. Too many Lagoon 450’s have contacted him with exactly the same … This article was gathered automatically by our news bot. We help YouTubers by driving traffic to them for free. The featured image in this article is the thumbnail […]
Continue Reading
We have finally dismantled enough of the cabins to start grinding the bulkheads. This is by far the worst job we have done on a boat. The whole inside of the … This article was gathered automatically by our news bot. We help YouTubers by driving traffic to them for free. The featured image in […]
Continue Reading
In this episode we finally get to assemble the cabins after rebuilding the primary bulkheads of our Lagoon 450 catamaran. The cabins could not be taken apart without being destroyed in some areas, so it was a difficult task getting it to go back together. But we are over the moon with the result! This […]
Continue Reading
